Description

Triple Clamp Set, CNC, Race, HRC Style, SP2

Designed and machined in house as a race replacement for the OEM triple clamps.

Crafted from aircraft spec 6061-T6 alloy for minimum weight and maximum strength.

The fork pitch and offset are the same as the OEM clamp.

Please note that this triple clamp set is for race use only, with reduced steering lock compared to the OEM triples, and was designed with the full HRC setup in mind.

The lower clamp includes a mounting position for a steering damper by way of an integrated M8 boss. No damper mounting hardware is provided.

Also, the top triple clamp has no provisions for mounting the ignition switch, so an alternative mounting position for the ignition must be found.

For correct fitting of the top triple clamp, the top preload lock nut and locking washer must be removed, and replaced with the TYLY-0371C spacer. This is the same fitting style as the true HRC setup.

For the individual top and lower triple clamp sets, please see the following products:

• TYLY-0371 Top Triple Clamp Set, CNC Black, Race, HRC Style SP2
• TYLY-0373 Lower Triple Clamp Set, CNC Silver, Race, HRC Style, SP2

If you are looking for SP1 triples, please see the following products:

• TYLY-2370 Triple Clamp Set, CNC, Race, HRC Style, SP1
• TYLY-0370 Top Triple Clamp Set, CNC Black, Race, HRC Style SP1
• TYLY-0372 Lower Triple Clamp Set, CNC Silver, Race, HRC Style, SP1

Tightening recommendations:

• Lower clamp pinch bolts: 23Nm.
• Top clamp pinch bolts: 23Nm.
• Fork Pitch: 214mm.
• Fork Offset: 30mm.